Service · FLD-04
Coolant & Glycol Supply
Inhibited propylene glycol and data-center coolants supplied to spec in BC and Alberta, with concentration engineered for your climate.
The problem
What's at stake
The fluid itself is where loops go wrong first: the wrong concentration for the climate, incompatible inhibitor packages mixed together, or bulk antifreeze that was never meant to meet a cold plate. Buying fluid without the chemistry math is how five-figure problems start.
FLD-04 · SCOPE
- Inhibited PG coolants matched to your equipment manufacturer's specification
- Concentration engineered for your location: a Vancouver loop and a Calgary loop should not be filled the same
- Delivery coordinated with fill or top-up service, not a pallet on your dock
- Compatibility check against your existing fluid before anything is mixed
- Disposal and replacement coordination for end-of-life fluid
What you receive
The right fluid, at the right concentration, with the compatibility check documented, delivered when your people are ready to receive it. Certificates of analysis included with every delivery.
Our commitment
We sell fluid the way a pharmacy sells medicine: against a verified need, with the interactions checked. If your existing fluid is fine, we will tell you so.
FAQ
Common questions
How much does glycol supply for a data center cooling loop cost?
Glycol supply is priced per facility, because volume, concentration, and the fluid your equipment manufacturer specifies all change the number. No flat per-litre rate is published, since the same order rarely fits two sites. The practical first step is to send your loop details through the contact form on this website and request a quote covering the fluid itself, the compatibility check against your existing fluid, and coordinated delivery, so you can compare it line by line.
What happens when I order coolant for my cooling loop?
Every order starts with a compatibility check against the fluid already in your loop, before anything is mixed. From there the concentration is engineered for your location, since a Vancouver loop and a Calgary loop should not be filled the same, and matched to your equipment manufacturer's specification. Delivery is coordinated with fill or top-up service rather than left as a pallet on your dock, and a certificate of analysis comes with every delivery.
Is it safe to top up my existing glycol with a different coolant?
It is only safe after the new fluid has been checked for compatibility with what is already in your loop. Incompatible inhibitor packages mixed together are one of the first ways loops go wrong, so a compatibility check is run and documented before anything is mixed. If testing shows your existing fluid is still fine, you will be told so rather than sold replacement fluid you do not need. When a top up is the right call, delivery is coordinated with the fill service itself.
Can I use regular bulk antifreeze in a data center cooling loop?
In most cases no, bulk antifreeze was never formulated to meet a cold plate, and running it in a data center loop is how expensive problems start. These loops typically need inhibited propylene glycol matched to the equipment manufacturer's specification, at a concentration engineered for the local climate rather than a generic mix. That is why supply here includes the chemistry work: spec matching, concentration for your location, and a certificate of analysis with every delivery.